Iwaver 02 PCB

Home › Forums › Mini-Z, Mini-X, X-Mods and other Mini-Scale › Mini-Z, Mini-X, X-Mods – Discussion › Iwaver 02 PCB

Viewing 4 reply threads
  • Author
    Posts
    • January 27, 2005 at 7:52 pm #12531
      aquaman02
      Participant
      • Posts: 11

      Hello, I am on a quest to build suped up xmod… I was wondering if anyone has an Iwaver02 PCB that I can use.. Would it be worth my while to also use the Iwaver02 servo or change it out to a HS-55?
      I am planing to do the Iwaver02 conversion with a Nelly Deluxe (I will wait for the new Nelly Deluxe like the website says.

      Here is my proposed setup:
      CF chassis,
      Rx-7 Body,
      CF drive shaft,
      All wheel drive,
      CXP alloy one piece top-plate,
      Iwaver PCB conversion,
      HS-55 Servo,
      Nelly Deluxe when it comes out,
      Lith-Ion Batteries, (2 x 3.6V)
      Full alloy suspension front and rear,
      Alloy Wheels,
      Metal Bearings,
      Atomic Mods Nuke 130 motor,
      Screw-in antenna

      Does anyone see any problems with the above setup (Other than it being an expensive venture)??

    • January 27, 2005 at 8:34 pm #58289
      z-beam
      Participant
      • Posts: 2265

      i dont think anyones just going to give you an iwaver02 pcb. thats a problem:smiley2:

    • January 28, 2005 at 2:03 am #58294
      betty.k
      Participant
      • Posts: 2487

      i’ve used the xmod servo with an i waver pcb and it’s fine, i don’t see a need to use a hitec.:8ball:

    • January 28, 2005 at 3:06 pm #58301
      aquaman02
      Participant
      • Posts: 11

      I didn’t know I need to be that specific.. I wasn’t asking for someone to just give me a PCB…. I need to buy one from someone who has one… Does anyone have an Iwaver02 PCB that I can buy?

      Betty k. Isn’t the Xmod servo worse than an HS-55.. I thought that the Xmods weren’t stepped as much as the mini-z and such,, hence the better steering in the kyosho cars..

    • January 28, 2005 at 4:55 pm #58302
      dgs73
      Participant
      • Posts: 2179

      i think z-beam’s point was you’ll have a hard time getting an iwaver02 pcb by it’s self, because no-ones likely to want to sell one and be left with an empty iwaver chassis (and who would?)… why not just get a chassis complete, minus tx and shell? Still cheap…

      Edited by – dgs73 on 28 January 2005 11:58:28

  • Author
    Posts
Viewing 4 reply threads
  • You must be logged in to reply to this topic.