Re: Help to indentify clone motors
Home › Forums › Bit Char-G, Digi-Q and other Micros › Bit CharG and Micro Radio Controlled – Technical › Help to indentify clone motors › Re: Help to indentify clone motors
March 17, 2003 at 8:54 am
#37102
Quote:
Very well observed Efarel :). I just bought myself four 4N28 opto-couplers to include in my design. I had trouble with the steering inputs in the TX2 chip no fully going to ground when connected to the output stage of the comparator. Using these opto-couplers should do the trick.
Thank you !
Go on with the good work ! I can’t wait your final post announcing to the world the good news….. “the Bit Char proportional emulator is finally born !!!”
Sadly I have to work this week end and next week I’m away so I’m unable to try your pre-final scheme.:angry:
Keep in touch !
Ciao dall’Italia,
Efarel