Cannot remove Stock Magnets!

[Tim]

I tried my best to remove the bottom spring from my Plasma Dash but with absolutely no luck at all:dead:

The spring is at the bottom and is stuck there like glue!

Here is the other side where two pieces of metal are bent inwards

http://f2.pg.photos.yahoo.com/ph/timmetal2003/detail?.dir=/2e74&.dnm=45d3.jpg

http://f2.pg.photos.yahoo.com/ph/timmetal2003/detail?.dir=/2e74&.dnm=fc3b.jpg

http://f2.pg.photos.yahoo.com/ph/timmetal2003/detail?.dir=/2e74&.dnm=fc3b.jpg

[Tim]

well the picture didn’t work out
the 1st picture’s link

http://f2.pg.photos.yahoo.com/ph/timmetal2003/detail?.dir=/2e74&.dnm=49ec.jpg

[SausaGe_LinK]

No pics work for me…
If you are putting in new magnets dont you get the can with the magnets ??
If you dont then why dont you try heating it up over a stove ?

[Tim]

sorry i didn’t make it so public can view it but try it again

[jamiekulhanek]

WHOA WHOA WHOA DO NOT PUT THAT THING IN AN OVEN OR YOU WILL DAMAGE THE MAGNETS.

Get a very small (-) type screw driver, and push it under the spring. this will make it pop up and come out very easily.

[SausaGe_LinK]

But if he is replacing the magnets then he doesnt have to worry about screwing them up

[Tim]

Thanks guys i got the magnet out by using Jamie’s way~

Thankz alot

But it was a spark when i took the spring don’t know why but it sure scared me for a while

[Author]

Posts