death of my bit

Home › Forums › Bit Char-G, Digi-Q and other Micros › Bit CharG and Micro Radio Controlled – Discussion › death of my bit

Viewing 6 reply threads
  • Author
    Posts
    • August 31, 2003 at 7:05 pm #11402
      RacerX
      Participant
      • Posts: 117

      One of my clones has passed away while racing in class I stoped the car for a moment and looked away next i heard a sound I hate *crunch* My butiful evo just went under one of my friends shoes :dead: I’ll post pics later but I’m going to try and transplant it with an old clone thats busted beyond repair. hey mabey I’ll make a tutorial out of it.:p

    • August 31, 2003 at 7:39 pm #36217
      barto_85
      Participant
      • Posts: 1321

      Dont worry, he’s gone to a better place 🙁 Good luck on the operation.

    • August 31, 2003 at 7:46 pm #36218
      RacerX
      Participant
      • Posts: 117

      the worst was it was my only 57mhz car. most of the damage is the body but the heat sink clip snaped off too which is the main problem

    • August 31, 2003 at 8:00 pm #36219
      barto_85
      Participant
      • Posts: 1321

      check this link out, it might help you a bit:
      http://www.ausmicro.com/topic.asp?TOPIC_ID=1081&FORUM_ID=9&CAT_ID=2&Topic_Title=Heat+sink+lip+keeps+snapping&Forum_Title=BCG+%2D+Technical

    • September 1, 2003 at 1:23 am #36224
      brendan
      Participant
      • Posts: 377

      hey racerx i had the same problem but nothing happend to the body umm i put some tape over the motor to tighten it then to keep it in better i got a magnet from the steering and i put it were the tab use to be the only problem is u cant use a body but ir car goes faster without a body.

    • September 1, 2003 at 12:34 pm #36231
      barto_85
      Participant
      • Posts: 1321

      yeah, but I also find it easier to lose control without a body, isn’t it brendan?

    • September 1, 2003 at 4:12 pm #36240
      z-beam
      Participant
      • Posts: 2265

      bit’s and tables are a bad combo, call your freind kong from now on.

  • Author
    Posts
Viewing 6 reply threads
  • You must be logged in to reply to this topic.