Driving Inconsistency

Home › Forums › Bit Char-G, Digi-Q and other Micros › Bit CharG and Micro Radio Controlled – Technical › Driving Inconsistency

Viewing 5 reply threads
  • Author
    Posts
    • December 2, 2003 at 6:47 pm #11930
      Admin
      Participant
      • Posts: 5952

      I recently purchased a 911 GT2 BitChar-G. It runs on a 27Mhz frequency on Band B and it is the only car in the area when i use it.
      So far i have not touched the internal parts of the car.

      When i am driving i experience the following:

        [*]Sometimes the car will not respond to the controler, even with a full battery and only being 30cm away from the controller.
        [*]Sometimes when i press forward / backward / left / right the car continues on that path for a few seconds before it stops turning / traveling.
        [/list]
        For the second point i thought it may be the controller button getting stuck but this doesn t appear to be happening.

        Any ideas?

    • December 2, 2003 at 7:37 pm #48339
      Admin
      Participant
      • Posts: 5952

      I have the Lamborghini Box set in 27MHz C and experience the same thing. I also have the Lamborghini Jota in 40MHz B – it’s not as bad but tends to suck a bit too.
      Are all the Super Bits this sucky or is it the metal plate in my skull again?

      Any Super Bit Char G mods anyone?
      😯

    • December 2, 2003 at 8:21 pm #48340
      ph2t
      Participant
      • Posts: 2088

      Fellas, this happens with the super bits. That’s why I sold mine! A lot of people have reported the symptoms listed above. Personally I think the super bits are junk.

      The 27Mhz are the worst offenders, the 40Mhz aren’t as bad and the range on them is a lot better than the 27Mhz ones.

      ph2t.

    • December 2, 2003 at 10:18 pm #48341
      betty.k
      Participant
      • Posts: 2487

      a lot of radio gear is on 27 mhz (cordless phones, toy walkie talkies, etc) so that could be a contributing factor:8ball:

    • December 2, 2003 at 10:19 pm #48342
      merc-blue
      Participant
      • Posts: 1547

      yeh… i cant run my mini z near my phone… or microwave…

    • December 5, 2003 at 6:38 am #48396
      Admin
      Participant
      • Posts: 5952

      I have found that everytime I lift my cordless phone off the hook my 27MHz car stops. You need to press on the controller to get it moving again.

  • Author
    Posts
Viewing 5 reply threads
  • You must be logged in to reply to this topic.