LXX vs Tomy PCB

Home › Forums › Bit Char-G, Digi-Q and other Micros › Bit CharG and Micro Radio Controlled – Technical › LXX vs Tomy PCB

Viewing 6 reply threads
  • Author
    Posts
    • December 17, 2003 at 2:54 am #11960
      Avatar photoKerosene
      Participant
      • Posts: 329

      I just took the gears (original orange Tomy), Perfection 4.2 motor, and rear axle out of my beaten up Tomy CCG and put them into a new LXX Super Perfection. The LXX goes nowhere near as fast as the Tomy did. None of my LXXs even get close to matching the Tomy using the same gears/motor.

      Is this a pcb thing?

      Edited by – Kerosene on 16 December 2003 21:59:47

    • December 17, 2003 at 3:43 am #48750
      Avatar photomicro_Amps
      Participant
      • Posts: 1290

      Most likely yes. They use different transisitors.
      :)uA

    • December 17, 2003 at 3:57 am #48752
      Avatar photoKerosene
      Participant
      • Posts: 329

      Fkn cheapo LXX 😀 👿

    • December 17, 2003 at 1:50 pm #48764
      Avatar photoHACHI-RYOKU
      Participant
      • Posts: 286

      Get them replaced with mosfets.

    • December 17, 2003 at 5:29 pm #48767
      Avatar photoph2t
      Participant
      • Posts: 2088

      Kero, were you in “perm boost mode” ie: running at full speed?

      ph2t.

    • December 17, 2003 at 6:32 pm #48769
      Avatar photoKerosene
      Participant
      • Posts: 329

      Yeah, I had it in ‘perm boost’ (sounds like 80s hairspray).

    • December 17, 2003 at 9:04 pm #48770
      Avatar photoph2t
      Participant
      • Posts: 2088

      lol, true that!

  • Author
    Posts
Viewing 6 reply threads
  • You must be logged in to reply to this topic.