pcb wiring

Home › Forums › Bit Char-G, Digi-Q and other Micros › Bit CharG and Micro Radio Controlled – Technical › pcb wiring

Viewing 5 reply threads
  • Author
    Posts
    • August 22, 2004 at 10:10 pm #12306
      lots_of_lobsters
      Participant
      • Posts: 101

      hey dudes, i was driving my SBCG and i hit a table, lost my right steering coz thw wire disconnected, then jammed the accelerator and fell down the stairs, and now i got heaps of wires loose, can anone tell me what goes where…anyone got a pic or sumhting? omg ok i got all thw wirse off including the antenna, cept 2 gold ones attached near each other on the corner od the PCB board…should i b worried that i losy like evry wire and theyre loose and im only a youngen and im no electronics wizz…?
      thanks guys
      rob

    • August 23, 2004 at 2:53 am #54995
      micro_Amps
      Participant
      • Posts: 1290

      This might help.
      Goodluck,
      uA

      http://www.ausmicro.com/tech/bitcharg/wiring-up-close/DSCN2598.JPG

    • August 23, 2004 at 9:33 pm #55014
      lots_of_lobsters
      Participant
      • Posts: 101

      na i got a super bit and its different PCB board to the normal ones…

    • August 30, 2004 at 1:55 am #55151
      lots_of_lobsters
      Participant
      • Posts: 101

      so anyone got any pics? i really wana get it working…

    • August 30, 2004 at 8:03 pm #55166
      Charlie Brown
      Participant
      • Posts: 105
      Quote:
      This might help.
      Goodluck,
      uA

      http://www.ausmicro.com/tech/bitcharg/wiring-up-close/DSCN2598.JPG

      I love this forum 😀

    • September 1, 2004 at 2:19 am #55216
      HACHI-RYOKU
      Participant
      • Posts: 286

      The wire placement is either the same or close to the same as a sbcg. Have a go at it. If you mix a wire or two, then just reverse what you did. It wont hurt anything to get a few wires mixed up. Just put the red wire at the positive spot / V+ spot is and the black wire goes to where it says grnd or -.

  • Author
    Posts
Viewing 5 reply threads
  • You must be logged in to reply to this topic.