Switch on the back of bit char g control?

[empirebayjmt]

What the hell is the switch on the back of the Super bit Transmitter ?
I know it is to slightly change the freq but the car only works on setting (a) when u switch to (b) or (c) the car dont work ??? whats the use in this also i was wonderin what the little hole just below the switch is cause it has a symbol of the motor near it with an arrow pointing to the hole ? r u meant to place your motor in there if so why ?

if ya still dont know what i am talkin bout look here 4 a pic 🙂
Just curious
:question:

http://www.ausmicro.com/gallery_display.asp?user=5905

Edited by – empirebayjmt on 07 February 2005 11:45:38

[z-beam]

the switch is so you can control different cars with the one controller. your sbcg is on the a frequency but there are also b and c frequencies on both 27 and 40 mhz for a total of 6 available channels/cars racing at once…

and as for the hole, it is there to help attach the small black gear onto the shaft of the motor

[betty.k]

in the case of the perfection copies, that switch is for permanent boost or 2 speed:8ball:

[jamiekulhanek]

It’s in the manual champ, place the pinion in the hole and push the motor shaft into it, it sets the correct depth.

[empirebayjmt]

i AM SILLY CAUSE I THREW THE MANUAL OUT tHANK U
Every1

[Author]

Posts