TX 2.3 and RX 2.2 PCB s

[jevries]

Hi people,

When I did surgery on my Lindberg 1/18 RC lowrider car I ve found a TX 2.3 chip in the controler and a TX 2.2 chip in my car.
They re not the useal square chips but the black blob covered ones.
It s a 3 channel operating vehicle but I really need an extra channel to lift the rear, maybe some of you know the pin layout of that chipset so I can make it happen.
It has 7 “pins” connector at each side instead of the useal 8.
I will post a pic soon.

Greets, J.

• This topic was modified 10 years ago by Aaron.

[jevries]

I marked the pins that are not connected red.
PCB controler:

PCB car

Edited by – jevries on 24 November 2004 01:07:05

[Author]

Posts