zz se

Home › Forums › Bit Char-G, Digi-Q and other Micros › Bit CharG and Micro Radio Controlled – Discussion › zz se

Viewing 3 reply threads
  • Author
    Posts
    • December 16, 2003 at 11:26 am #9891
      Impreza
      Participant
      • Posts: 1124

      just picked up the FC3S Rx7 ZZ SE from the States. Very nice and heavy too. Picked up a couple of microsizer Rx7 shells as well (for future bit body mods:) u, or anyone else look into the small board that controls the leds? just wondering.. Will have to play with it a little before taking it apart.

    • December 16, 2003 at 11:34 pm #38757
      micro_Amps
      Participant
      • Posts: 1290

      In what way Imprez, are you thinking of a potential mod there?
      I dont think it actually controlls the leds, its just a spot that the leds connect to, the pcb turns the lights on when you drive.
      :)uA

    • December 17, 2003 at 7:06 am #38712
      Impreza
      Participant
      • Posts: 1124

      actually I was wondering about this for future potential mods. I think it is a good idea to have a centralization for the lights rather than wires all over the place, imo. Also was curious why there were four wires coming from the car, unless fwd and rev are included as well as +ve and -ve? I think I might of just answered my question:shock:

    • December 17, 2003 at 11:32 pm #39420
      micro_Amps
      Participant
      • Posts: 1290

      Yes I think you just did.
      :)uA

  • Author
    Posts
Viewing 3 reply threads
  • You must be logged in to reply to this topic.