merc-blue

Forum Replies Created

Viewing 25 posts - 751 through 775 (of 1,455 total)
1 2 3 … 30 31 32 … 57 58 59
  • Author
    Posts
  • July 25, 2004 at 12:28 pm in reply to: another melb. meet #30792
    merc-blue
    Participant
    • Posts: 1547

    goodo it will be good 2 see you there iff you make it (if you do come turn in at the football club then follow the road to the praking sort… my folks always miss that )

    July 25, 2004 at 3:34 am in reply to: Can you water proof mini Z #53958
    merc-blue
    Participant
    • Posts: 1547

    easy as.. just cover all teh electronics in silicon (like in a 1:10 (inside my receiver is a PCB covered in silicon.. also seal the servo

    July 25, 2004 at 3:31 am in reply to: Kyosho@12 #53957
    merc-blue
    Participant
    • Posts: 1547

    yeh it seems abit lame.. i mean 1:12 cummon u either go small or big not this lame in between

    July 24, 2004 at 4:53 pm in reply to: Mini-z chassis change #53938
    merc-blue
    Participant
    • Posts: 1547

    ball diff if you dont have one its the second hop up you should get after bearings

    July 24, 2004 at 3:06 pm in reply to: Homemade Chassis #53935
    merc-blue
    Participant
    • Posts: 1547

    kitsune. a custom chassis is a big job i got a few suggestions…
    1. do it in plates eg. a bottom plate thena top plate
    2. make the rear so it can just join ont a H plate
    3. keep the fround asembly petty much the same (save pissing around with servos)

    July 24, 2004 at 3:02 pm in reply to: Mini-z chassis change #53934
    merc-blue
    Participant
    • Posts: 1547

    yeh its all screwed together as kitsune said ther is absolutley no soldering needed

    July 24, 2004 at 1:41 pm in reply to: what s a good ESC for a MRS4?? #53930
    merc-blue
    Participant
    • Posts: 1547

    hey im getting a losi mini-t some time this week.. 😀 and was wondering wat esc looks like the Gm or LPR but any one know any sources?

    July 24, 2004 at 12:45 pm in reply to: what s a good ESC for a MRS4?? #53929
    merc-blue
    Participant
    • Posts: 1547

    hey adamc welcome to the forums. so your a MRS4 runner u got ne thing else RC

    July 24, 2004 at 12:40 pm in reply to: charging AAA s #53928
    merc-blue
    Participant
    • Posts: 1547

    yeh icebreaka look for a nicd/nimh delta peak

    July 24, 2004 at 12:39 pm in reply to: Mini-z chassis change #53927
    merc-blue
    Participant
    • Posts: 1547

    there mainly a asthetic thing no soldering required just lots of screwes

    July 24, 2004 at 1:13 am in reply to: overheated car #30840
    merc-blue
    Participant
    • Posts: 1547

    my point exactly i live in balwyn (its abit snobby) and with my shitty english they think im for coboug or sumthing (no offence to any one form coboug)

    July 24, 2004 at 1:09 am in reply to: charging AAA s #53918
    merc-blue
    Participant
    • Posts: 1547

    yeh that will do it.. and yeh hook that up to a 4 AAA pack and you will do it you will beable to charge them like jamie said much faster then the rcmarts ones.. just a note (these all have 12V inputs) so you can use either a car battery/gel cell to power it or a 12v power supply with a current rating for a few amps

    July 24, 2004 at 1:05 am in reply to: Foam tiles for mini-z tracks #53917
    merc-blue
    Participant
    • Posts: 1547

    lol always good to hear that my oppinion is somtimes the rite one

    July 24, 2004 at 1:04 am in reply to: charging AAA s #53915
    merc-blue
    Participant
    • Posts: 1547

    lol jamie i do mine at 4.5 amps and just sit forzen peas ontop and they dont heat up THAT much

    July 24, 2004 at 12:58 am in reply to: charging AAA s #53912
    merc-blue
    Participant
    • Posts: 1547

    most chargers do both nicd/nimh (pretty much the same chargin sequence)

    July 24, 2004 at 12:48 am in reply to: charging AAA s #53910
    merc-blue
    Participant
    • Posts: 1547

    well a standard charger supplys a set current a delta peak can supply a varity of different currents set by a knob on the front mine does up to 10 amps (which will blow most standard batteys only high capacity batterys cna be cahrged).. u can do low current for battery condidtioning and high current for quick charging between races… a delta peack can have the batterys set in them “charging for a month” and not over charge try it with a standard charger (DSE sorta thing)and you will have a fire.. yeh 15 mins on a high curent

    July 24, 2004 at 12:39 am in reply to: Foam tiles for mini-z tracks #53908
    merc-blue
    Participant
    • Posts: 1547

    hmm i dont know there i fine cell foam .. they dont have great grip and joins arent great (if i was you i would go to clark rubber and buy a roll of recycled tyre rubber it will be cheap and very grippy and also rollable … just need foam tyres and would be perfect

    July 24, 2004 at 12:36 am in reply to: charging AAA s #53907
    merc-blue
    Participant
    • Posts: 1547

    a delta peak cheack the output of the batterys and stops when there fully charged and then swaps to a trickle charge (to keep them charged fully untill you check) you can vary the input to your cells to vary charging times.. the ice pack its too keep the cells cool (because of high input) all the 45 min charger will be is a standard charger .. with a higher current (my cheapo charger does them in 5 hours with its output this thing wil have a higher output to charge them faster.. pretty simple the 45 mins thing is abit of a gimick i think.. you basically plug them in and do some math to work out a suggested charge time but never fully charged becasue you dont know about residual charge the worked charge time is always abit undercharged etc etc etc .. if you dont get that tell me and i will re phrase it all

    July 24, 2004 at 12:25 am in reply to: charging AAA s #53905
    merc-blue
    Participant
    • Posts: 1547

    17.90 USD + postage.. i would get a 2nd hand delta peak off ebay .. can do them in 15 mins (with a ice pack)

    July 24, 2004 at 12:19 am in reply to: Mini Z RC Car Clubs Sydney ? #53904
    merc-blue
    Participant
    • Posts: 1547

    lol yeh at the track down here they let a regular put a MRS4 on track with the novices.. which was harsh casue he won… and talldude the minis are great.. if you dont got one get on

    July 23, 2004 at 11:51 pm in reply to: Kyosho Lazers #53901
    merc-blue
    Participant
    • Posts: 1547

    4WD always good and cheap but i already told you that… correct me if im wrong.. good chassi but shocks abit dodge and need bearings (like all RCs) … (posted for the masses)

    July 23, 2004 at 10:39 pm in reply to: charging AAA s #53899
    merc-blue
    Participant
    • Posts: 1547

    z-beam a delta peak is a much better charger than a ni-cad/nimh charger (if its a set for a time period then com back) unless its a delta peak which most arent

    July 23, 2004 at 10:37 pm in reply to: overheated car #30896
    merc-blue
    Participant
    • Posts: 1547

    nah i learned australia first.. im as white/english as it gets

    July 23, 2004 at 9:59 pm in reply to: VIDEO – iwaver vs MR-02 #53895
    merc-blue
    Participant
    • Posts: 1547

    lol nice one ph2t.. but y dont you say the truth… the doctor should have put u back when ur mum gave birth 2 u casue theres deffiently somthing wrong

    July 23, 2004 at 8:58 pm in reply to: ausmicro website speed #30890
    merc-blue
    Participant
    • Posts: 1547

    its arite were all having site issures

  • Author
    Posts
Viewing 25 posts - 751 through 775 (of 1,455 total)
1 2 3 … 30 31 32 … 57 58 59