Tim

Forum Replies Created

Viewing 25 posts - 1 through 25 (of 246 total)
  • Author
    Posts
  • in reply to: “Sanyo” AAA NiMHs #23446
    Tim
    Participant
    • Posts: 267

    I saw the 900 Sanyo here too in Hong Kong when i was browsing through the 20 diff. rc hobby shops~

    in reply to: Get your Bearings Here! #55069
    Tim
    Participant
    • Posts: 267

    Aaron what brands are the wheel nuts?

    in reply to: GP 950mah! #54186
    Tim
    Participant
    • Posts: 267
    Quote:
    I dont get it, Whats the extra 50 or even 150 going to do, If anything a longer run time and they take longer to charge….:dead::angry::evil:
    WHY ???????

    Pete you won’t see 50mah difference but 150mah u would see a difference about 5-10 extra min! I mean 4 sets of 950mah would run extra half hour or more!

    Dgs, I don’t think the 950’s are officially on the shelve yet because i tried looking for them on the internet no luck 🙁

    For i know, GP batteries have vents like hole at the top of the battery in which i never seen in Sanyo & Powertech~

    in reply to: GP 950mah! #54544
    Tim
    Participant
    • Posts: 267
    Quote:
    I dont get it, Whats the extra 50 or even 150 going to do, If anything a longer run time and they take longer to charge….:dead::angry::evil:
    WHY ???????

    Pete you won’t see 50mah difference but 150mah u would see a difference about 5-10 extra min! I mean 4 sets of 950mah would run extra half hour or more!

    Dgs, I don’t think the 950’s are officially on the shelve yet because i tried looking for them on the internet no luck 🙁

    For i know, GP batteries have vents like hole at the top of the battery in which i never seen in Sanyo & Powertech~

    in reply to: Smaller Than a z, Faster than a char-g #30346
    Tim
    Participant
    • Posts: 267
    Quote:
    MmM looks like a 4wd rc race that can only go forward and left or sumfin??

    do the tires fit Z’s???

    No is not a 4wd, is 2wd rear powered!

    It has a weird servo, many servos~

    Sorry the pictures were big because i only figured out i had my camera at max pixel!! like 1280×800 or something.

    I’m planning to shove a Plasma Dash inside it later when i figure out what kind of FETS it uses. It would be screammingg!

    in reply to: Mini Z RC Car Clubs Sydney ? #54063
    Tim
    Participant
    • Posts: 267

    Guys i’ll ring up and check out the prices for u ASAP when i’m free, you are looking about $20-30 if i’m not wrong, but i won’t be showing for a while since school started~

    in reply to: Mini Z RC Car Clubs Sydney ? #54421
    Tim
    Participant
    • Posts: 267

    Guys i’ll ring up and check out the prices for u ASAP when i’m free, you are looking about $20-30 if i’m not wrong, but i won’t be showing for a while since school started~

    in reply to: rcmart group order #54062
    Tim
    Participant
    • Posts: 267

    Put me down for a

    yeah racing servo pot
    http://www.rcmart.com/catalog/product_info.php?cPath=144_21_150&products_id=2356

    betty.k i’m going get my mine w00t!

    As for the delivery is it the same as the Toyeast buy where a person gets all the stuff in that state and then distributes them out during a meet?

    Like the package goes to dgs then he distributes it out to the sydney folks.

    As for the shipping Ph2t how we calculating it?

    in reply to: rcmart group order #54420
    Tim
    Participant
    • Posts: 267

    Put me down for a

    yeah racing servo pot
    http://www.rcmart.com/catalog/product_info.php?cPath=144_21_150&products_id=2356

    betty.k i’m going get my mine w00t!

    As for the delivery is it the same as the Toyeast buy where a person gets all the stuff in that state and then distributes them out during a meet?

    Like the package goes to dgs then he distributes it out to the sydney folks.

    As for the shipping Ph2t how we calculating it?

    in reply to: Mini Z RC Car Clubs Sydney ? #54019
    Tim
    Participant
    • Posts: 267

    I know a place where there are 20 packets or more servo for sale near my area, about $12. They also sell x-speed light kit and etc.

    I really should take a photo of the material i got at home before you guys start spending money on materials for track

    in reply to: Mini Z RC Car Clubs Sydney ? #54377
    Tim
    Participant
    • Posts: 267

    I know a place where there are 20 packets or more servo for sale near my area, about $12. They also sell x-speed light kit and etc.

    I really should take a photo of the material i got at home before you guys start spending money on materials for track

    in reply to: Mini-z chassis change #53932
    Tim
    Participant
    • Posts: 267

    Wouldn’t you have to solder the lines to the switch in order to run the car?

    in reply to: Intermittent timeouts connecting to this site #31021
    Tim
    Participant
    • Posts: 267

    lucky i got cable, the timeout only happens to me every now and than but a couple of quick ‘refresh’ usually does the work

    in reply to: Venues etc etc ra ra ra ra #53841
    Tim
    Participant
    • Posts: 267

    I know a friend that races his 1/10 car in Eastern Creek’s netball court, apparently that court is pretty big probably bigger than Meadowbank~ Someone check it out and see if its any good:smiley2::smiley2:

    in reply to: Intermittent timeouts connecting to this site #30439
    Tim
    Participant
    • Posts: 267

    Same here, i thought it was my problem at first but it happened at school as wellblackeye:

    Posting is becoming a hard problem, i would time out after a post so u’ll b tempted to click the button again and later figuring u have poster twice :dead:

    in reply to: Mini Z RC Car Clubs Sydney ? #53711
    Tim
    Participant
    • Posts: 267

    nah this surface is different sorry i forgot to mention it, it’s similar to the surface to the one in Meadowbank, it’s not timberflooring like the traditional indoor basketball it uses another material, is a new built basketball court. From my memory it doesn’t have wax on it so it would stop the car from skidding.

    in reply to: Mini Z RC Car Clubs Sydney ? #53706
    Tim
    Participant
    • Posts: 267

    Arr.. that kid on bike… Anger:angry::angry:

    that kid nearly ran over it and everyone was is shockblackeye:lol
    I sorted wanted to him to run over it so i can have an excuse to buy a new car.

    Yea Geo i gave the rings to Dgs, One ring is soldered to a cable already and one ring is just by itself. I saw the rings before at Dick Smith very similar.

    pete as for the track i tried to look around in my area as well, not much luck mostly soccer and rugby fields. I mean we could book a indoor basketball court, i know one in kellyville reasonably cheap. You can book half court or full court. I’ve seen people book it for karate training but i doubt they will allow us 2 race, skid marks and etc.

    in reply to: MINIZ PCB ON/OFF switch #53685
    Tim
    Participant
    • Posts: 267

    hahah that would be incredibly funny if Talldude or one of your car blowsblackeye:blackeye:. Merc by blowing do u mean actually explosion or just smoke and melting the chasis?

    in reply to: my “Woah Nelly!” Turbo…. #53684
    Tim
    Participant
    • Posts: 267

    I had the same idea of stacking the FETS on the whoa nelly. If one whoa nelly FETS is equilavent to 12×2 7389 and if i stack it 6×2 of whoa nelly FETS that equals to 72 7389!!!!!!:shock::shock:

    My dream is now get heaps of whoa nelly and stack them and called them the ‘unfrieable’ and sell them and beat ph2t :smiley2::smiley2:

    in reply to: Mini Z RC Car Clubs Sydney ? #53671
    Tim
    Participant
    • Posts: 267

    Yea talldude is a kid, eating away with his chocolate bar hahahha

    in reply to: Mini Z RC Car Clubs Sydney ? #53649
    Tim
    Participant
    • Posts: 267

    right… z-nagual….

    Freezing day today car had all sorts of problem same as TD and dgs hope i can fix it or looks like a new car coming to me 😀

    Geo-z get well i gave the rings you wanted to dgs just grab them off him next time you see him

    in reply to: Are there any Aussie, car models to fit Z? #53569
    Tim
    Participant
    • Posts: 267

    rofl:D

    in reply to: Mini Z RC Car Clubs Sydney ? #53568
    Tim
    Participant
    • Posts: 267

    41996294WmxMWJ_ph.jpg

    This is dedicated to you kev.:D

    The previous excuses weren’t excuse since they were TRUE

    The FETS did get fried and Ph2t u know it better than me:dead:
    My car did get serivced in Melbourne
    I was coming to go and dgs knows that i ran him to see if we were still going on sunday when it was raining.

    Yea i do need wheel nuts because they are stripped:p

    in reply to: Mini Z RC Car Clubs Sydney ? #53567
    Tim
    Participant
    • Posts: 267

    yea several problems i still have to fix. The resistor thingy in the servo is causing all sorts of trouble i tried the paper technique fixed a bit but still it twitches like hell!

    My car seemed to have range up to 10m and thats all! Don’t know why after 10m my car goes nuts and loses control.

    My car still can’t go straight might send it down to betty.k to see if he can fix it but that later on. I tried to turning the POT thing on the PCB to see if it would fix it but pfft same thing.

    As for saturday yea i can come but it would be better if more people can come
    :smiley16:

    in reply to: Mini Z RC Car Clubs Sydney ? #53553
    Tim
    Participant
    • Posts: 267

    Is a whoa nelly 1.1 a typo which i never bothered to fix up.

    But i read the weather report (rare occasion) there is rain in the late afternoon of saturday~

    It looks fine not much cloud in my area should be fine on saturday by the looks of it.

    TD can’t see my whoa nelly plasma in action muhahahahahah(evil laugh):evil:

Viewing 25 posts - 1 through 25 (of 246 total)