@betty.k 225459 wrote:
eg: in a 4 cell mini z you will use 2 cells for break in.
also during break in you should run the motor with no load and wired directly to the cells, don’t break a motor in by running it installed at low throttle on a stand.
the desired result of a break in is to have the brushes making full contact with the commutator. so how long you do it for depends on how long that process takes.
in a 130 sized z motor that could take up to an hour with new brushes but something like 15 – 30 mins should be enough.
put some oil on the bushings too.
:8ball:
hey there.
Get a battery craddle for 2 aaa, connect a red and black wire to it if it has not got them already, wack on a terminal block to the wires solder and heat shrink over, connect your motor to it and your of…
Do as betty has said to in the first option…
Hope this helps.:beer:
