jamiekulhanek

Forum Replies Created

Viewing 25 posts - 1,651 through 1,675 (of 2,484 total)
  • Author
    Posts
  • in reply to: How cool is your ride??? #33309
    jamiekulhanek
    Participant
    • Posts: 2563

    his imaginary camera that he doesnt have??

    in reply to: settings to drift #33308
    jamiekulhanek
    Participant
    • Posts: 2563

    I find too much speed makes it spin out rather than drift, but im talking about concrete.

    in reply to: rear suspention #33424
    jamiekulhanek
    Participant
    • Posts: 2563

    Its not a great idea to have a varying gear mesh.

    I think a H plate design with a separate motor pod would be great.

    in reply to: Initial D RX7 FC zip zaps.. #33423
    jamiekulhanek
    Participant
    • Posts: 2563

    want want want……prolly cant have….

    in reply to: The R32 project…. #33422
    jamiekulhanek
    Participant
    • Posts: 2563

    Ph2t always manages to amaze me with his innovative ideas…

    in reply to: Does suspension make a difference #33421
    jamiekulhanek
    Participant
    • Posts: 2563

    I think tyres make more difference, but sure the swaybars and springs do make the car perform better, just drive the car with no swaybar and see the difference.

    in reply to: You’re all a pack of lazy bastards!!!! #39703
    jamiekulhanek
    Participant
    • Posts: 2563

    Who are those lazy bastards?? I havent got anything right this second but might see what i can whip up. Very busy with a far BIGGER project atm, cost me $350 so far, only half completed.

    in reply to: You re all a pack of lazy bastards!!!! #47269
    jamiekulhanek
    Participant
    • Posts: 2563

    Who are those lazy bastards?? I havent got anything right this second but might see what i can whip up. Very busy with a far BIGGER project atm, cost me $350 so far, only half completed.

    in reply to: Track timers #39702
    jamiekulhanek
    Participant
    • Posts: 2563

    Nah to monitor 6 cars its quite expensive. Contact aaron for 6 car timers.

    I have seen bit char-g timers, that monitor one car’s time. It has an lcd screen and beeps when you make a faster lap time.

    in reply to: settings to drift #39701
    jamiekulhanek
    Participant
    • Posts: 2563

    I think the bog stock mini z with ball bearings drifts the best.

    in reply to: settings to drift #39700
    jamiekulhanek
    Participant
    • Posts: 2563

    Think of MAH as the size of a petrol tank, the bigger the number the bigger the storage.

    Higher voltage gives more power, but not all cells will hold voltage under load.

    in reply to: 14t pinion #47268
    jamiekulhanek
    Participant
    • Posts: 2563

    I would if i could find the software disk for my Digi cam…..and besides they would be crap cause i bought my camera in 1997 (casio QV-10).

    I know i sound like our friend VR-4, but ask anybody, im no liar.

    in reply to: Kyosho Palm Runners… #47267
    jamiekulhanek
    Participant
    • Posts: 2563

    The Dash has gargantuous torque compared to the x speed motor, so a 14 tooth pinion would push it to about 55km/h.

    in reply to: Plasma Dash Motor Questions & some other q s #47266
    jamiekulhanek
    Participant
    • Posts: 2563

    The mini Z pcb already has a small SMD capacito between the motor terminals but one more would do even more good i guess.

    Aswell as smoothing out spikes cause by the arcing of the commutator (blue sparks) it also significantly increases motor life, because the sparking causes extreme heat, the same temperature as a welder.

    in reply to: Kyosho Palm Runners… #47263
    jamiekulhanek
    Participant
    • Posts: 2563

    My plasma did 37km/h once i installed ball bearings in the motor. But i am yet to charge the batteries on a peak charger so those figures could change.

    in reply to: some info on tamiya min 4WD motors #47262
    jamiekulhanek
    Participant
    • Posts: 2563

    BUT the mini z has 4 cells a mini 4wd only has 2 cells so those figures arent accurate for a mini z.

    in reply to: 14t pinion #47259
    jamiekulhanek
    Participant
    • Posts: 2563

    U would have to modify the motor clip and make a bigger spacer to accomodate the 14t pinion. I think the Plasma Dash has plenty of torque to turn a 14t pinion.

    in reply to: How cool is your ride??? #33953
    jamiekulhanek
    Participant
    • Posts: 2563

    ……that hits 500mph in 2 sec but it get hot and explodzes so i don use it and ill get pics one day prolly never

    in reply to: Initial D #36327
    jamiekulhanek
    Participant
    • Posts: 2563

    OK, what rank are you guys??

    Im ranked #23 in aus, bunta still beats me by 150m or so 🙁 but i can kick tak’s ass by heaps.

    MS charged, i am talking about the Arcade initial D, the one you stick money in to play, s are you saying that ts easy on ps2, and alot harder on the machine??

    in reply to: Boronia (Vic) Enduro #47150
    jamiekulhanek
    Participant
    • Posts: 2563

    I am considering it, but its too much i.e. food, accom, transport, airfares etc. Ahh well maybe next time.

    in reply to: Limo pics #35824
    jamiekulhanek
    Participant
    • Posts: 2563

    damn thats cool. More motors too i spose.

    in reply to: Limo pics #35527
    jamiekulhanek
    Participant
    • Posts: 2563

    damn thats cool. More motors too i spose.

    in reply to: Boronia (Vic) Enduro #47148
    jamiekulhanek
    Participant
    • Posts: 2563

    I’d love to go…hmmm tickets aren’t all that dear. And i don’t have a car and wouldn’t like to drive another person’s cause im not much of a driver.

    in reply to: terrorist car!!!! #35807
    jamiekulhanek
    Participant
    • Posts: 2563

    The bit will be far away tho.

    in reply to: terrorist car!!!! #35510
    jamiekulhanek
    Participant
    • Posts: 2563

    The bit will be far away tho.

Viewing 25 posts - 1,651 through 1,675 (of 2,484 total)